Ebike Anti-Theft Alarm
Security for your Electric Bicycle
 Keep your ebike safe and secure on the road!
Available on all Veloteq Ebikes
- Features
- Operation
- Specifications
Features
The Veloteq Anti-Theft Alarm System is designed to help prevent tampering or
theft of your ebike. It is fully integrated factory-installed system.
Simply carry it with you with your key attached and control the system from
anywhere within 230 feet (70 meters). Operation is simple using the digital
display on the remote control.
Depressing the activation key causes the loudspeaker to emit a "prompt" signal
letting you know that the system is armed.
While in the armed state, if vibration is detected the alarm will trigger
immediately, the loudspeaker will sound intermittently for 5 seconds; the alarm
will again sound after 15 seconds if vibration continues the loudspeaker will
again emit a long, continuous signal.
In the security alert state, attempting to use force to start the vehicle will
cause the
loudspeaker to emit a continual loud alert.
Suspending or releasing the alarm is simple using the remote. To release
temporarily while the alarm is sounding, depressing and holding the alarm key
will temporarily halt the alarm signal while maintaining the system in the armed
state. To release the vehicle from the alarmed state, depress the alarm key, the
loudspeaker will sound twice releasing the vehicle from the alarmed position.
The shock and vibration sensitivity is programmable using the remote. While in
the alarm system release state, depressing the loudspeaker key for 5 seconds
will enter the sensitivity adjustment mode. Select 0 for high sensitivity,
center (two) for low
sensitivity or (three) to circulate. After confirmation the selection is
activated.
Bike Locater-Can't find where you put your ebike? In either the armed or unarmed
state continuously depressing the alarm key will cause the loudspeaker to emit a
continuous sound until the key is released.
Back to Top Operation
1. Acoustical Security
Depressing the activation key causes the loudspeaker to emit a “prompt”
signal.
After 3 seconds the alarm apparatus automatically enters the armed state.
2. Motion Alarm-While in the alarm position, when vibration is detected the
alarm will trigger for the first time, the loudspeaker sounds intermittently
for 5 seconds, and the motor is unable to start; the alarm will again sound
after 15 seconds if vibration is detected and loudspeaker will again emit a
long signal for 15 seconds, the motor is disabled.
3. Emergency Alarm-In the security alert state, attempting to use force to
start the vehicle will cause theloudspeaker to emit a continuousloud alert.
4. Suspending the Alarm-While the alarm is sounding, depressing the alarm
key will temporarily halt the alarm signal while maintaining the system in
the armed state.
5. Releasing the Alarm-While in the alarmed state, depress the alarm key,
the loudspeaker will sound twice
releasing the vehicle from the alarmed position.
7. Vehicle Locater=In either the armed or unarmed state continuously
depressing the alarm key will cause the loudspeaker to emit a continuous
sound until the key is released.
Back to Top Specifications
1. System working voltage: 12V
2. System Idle Current: <7MA
Discharge Current: <60MA
Controller: Emission Current: <4MA
3. Transmission Frequency: 315MHZ +-75KHZ
4. Remote control service range: 230 feet/70 meters (open area)
5. Alarm Sound Pressure Level: >100dB
Back to Top
|
